Cheie fixă Gedore 6576540

The Gedore 6576540 open end wrench is manufactured from vanadium steel (31CrV3) and conforms to DIN 894 and ISO 3318 standards. The wrench has jaws set at 15° and is finished with manganese-phosphate on sizes up to 38 mm and steel-grey finish from 41 mm upward. Available in sizes from 10 mm to 135 mm and equipped with a hanging hole, this open end wrench weighs 374 g and is intended for general mechanical use.

Advantages

The open end wrench offers standardized dimensions (where applicable) and a jaw angle of 15° for improved access in tight spaces. Gedore's vanadium steel construction (31CrV3) provides strength and durability. The manganese-phosphate or steel-grey finish increases surface protection. A hanging hole simplifies storage.

Suitable for

Key specifications

How to use

Select the correct wrench size for the fastener, position the jaws squarely on the flats of the nut or bolt, and apply steady torque. Use the 15° jaw offset to gain clearance in confined areas by flipping the wrench as needed. Avoid using the wrench as a hammer or on rounded fasteners; inspect the tool regularly for wear.

Recommendations

For long service life, keep the wrench clean and lightly oiled to protect the finish. Store on a rack using the hanging hole. Replace the tool if jaws become rounded or if any visible cracks appear.